(50d) Fast and Slow Pyrolysis of Lignin Extracted From Prairie Cord Grass, Aspen, and Kraft Lignin

A study is undertaken to assess the effectiveness of lignin extracted from prairie cordgrass as a pyrolysis feedstock. The effects of variability of lignin source on fast and slow pyrolysis products are also investigated. To accomplish these goals, Py-GC/MS and TGA/FTIR are employed in the pyrolysis of three types of lignin: prairie cordgrass (PCG) lignin extracted from prairie cord grass, aspen lignin extracted from aspen trees (hardwood), and synthetic Kraft lignin. Fast pyrolysis results from Py-GC/MS show that for PCG lignin only ten of the detected compounds have relative peak area percentiles that exceed 2% and make up over 52% of the total area. For aspen lignin, excluding butanol that is used in the extraction process, only eight compounds are found to have relative peak areas exceeding 2% that make up over 52% of the total area, as is the case for Kraft lignin where again eight compounds exceeding 2% are found to make up more than 45% of the total area. Both techniques, Py-GC/MS and TGA/FTIR, indicate that PCG lignin releases more alkyls than aspen and Kraft lignin. TGA/FTIR results indicate that PCG lignin also releases by far the most light volatile products (<200°C) while producing the least amount of char among the three types of lignin studied. These characteristics make PCG lignin a good choice in producing good quality bio-oil and thus decreasing upgrade requirements. Py-GC/MS results conclude that aspen lignin produces significantly more pyrolytic products than PCG lignin. This is indicative of the potential of aspen lignin to result in higher conversion rates of bio-oil than the other two lignins.