(125e) Optimization and Scale up of Dry Impregnation Using DEM Simulations
AIChE Annual Meeting
2014
2014 AIChE Annual Meeting
Particle Technology Forum
Dynamics and Modeling of Particulate Systems I
Monday, November 17, 2014 - 1:55pm to 2:16pm
Impregnation of active metals onto a porous catalyst support is an important step in the preparation of catalyst. In a typical dry impregnation process, metal solutions are sprayed over a particulate bed in a mixing vessel until the pore volume is reached. The inter-particle variability of metal content may significantly affect the activity and selectivity of the resulting catalyst. Current scale-up practices lead to poor fluid distribution and inhomogeneity in metal content. The aim of this work is to understand the dynamical behavior of the particles under the spray nozzle, which is essential for desired content uniformity, and to develop a scale-up model for the dry impregnation process.
DEM simulations are performed in both cylindrical vessel and double cone blender. The latter is known to have poor mixing in the axial direction. Two dimensionless numbers are used to characterize the scale up of the system: Froude number (Fr) and Spray Flux number (Ψ). The Froude number is defined as the ratio of inertial force to gravitational force. The calculation gives the correlation between rotation speed (ω) and vessel size (R). Spray Flux number measures the density of spray droplet in the spray zone. The location and area of spray zone can significantly affect the overall content uniformity. Results in the cylindrical vessel show that a homogeneous liquid distribution with optimal particle mixing is obtained by minimizing the spray rate and Ψ for an optimal Fr number. The rules are further examined in the double cone geometry, where three different rotation speeds (7rpm, 15rpm, and 25rpm) are compared with three different spray rates (1.5L/hr, 3L/hr, and 5L/hr). It is found that slower rotation speeds while keeping Fr number at the optimal value and lower spray rates increase the content uniformity of the resulting particles.
In order to reduce the entire process time, a 2-stage spraying method is tested in the cylindrical vessel. For the first half of liquid depletion, the particle bed is sprayed at twice as much the flow rate as for the second half. The content uniformity is compared with individual and optimal spray rates. Our results show good content uniformity for both the 2-stage and the optimal spraying methods. The spraying time is reduced 30% with respect to the optimal 1-stage spraying method. The distributions of particle water content show a similar trend.
Using the cylindrical vessel, the effect of particle size on the overall mixing and metal content uniformity is studied. The optimal conditions previously ascertained (7rpm of rotation speed and 0.3 L/hr of flow rate) are used as a baseline for comparing different particle sizes (4.7mm, 3mm, and 2.4mm). Results show that in the smaller particle system, mixing is slower, which leads to a poor content uniformity. Furthermore, mixing and content uniformity are studied for mixtures of different particle sizes. Binary system is composed of 50% of small particles (2.4mm) and 50% of large particles (4.7mm). Tertiary system has 1/3 of each of the three particle sizes. In the particle mixtures, small particles tend to pass through the interstices of the large particles when they are flowing, and heavy particles tend to roll down the sloped bed surface, resulting in particle segregation and poor content uniformity.